@DrBluesVJ wrote:
Hi,
when you fasten movers on trust this is sometimes impossible to fix them very precisely in P/T position.
It will be very usefull possibility to trim P/T position of each fixture from M-PC.
It is easy idea:
Simply add two additional parameter's box in each row right to INVERT parameter in patch window. First for PAN trimming, second for TILT trimming.
By default both values should be ZERO - nothing happen.
If you want to trim a little bit one of parameter you can add or subtract value and this value will be additional constant value to every P/T values generated as DMX P/T control signal for particular mover.
This additional value should be entered as absolute 16-bit number or as degree or with up/down arrows (+1/-1) with low or higher step etc.
Good idea will be not to restrict range of trimming, so you can even change P or T position over < -90 +90 > degrees or more.
Very easy and very usefull
Posts: 2
Participants: 1